Bluworld of Water CSHDBM Manual de Instruções descarregar pdf (Página 5)

Step 4.1 Locate your level tool and draw a line on the wall indicating the top of the waterfall. Measure down from the

line down approximately 8 ¾” and draw another line to indicate the center of the Wall Bracket (H). Using a

level, hold the Wall Bracket (H) to the wall with the top angled towards you. Mark both mounting holes on the

wall. Remember to double-check your measurements. See illustrations below.

Step 4.2 To install the EZ Anchors™ (E), gently tap or press the tip into the drywall and slowly screw the anchors into

the wall. See Fig 2.A. Make sure the flat side of the anchor is flush with the wall. Do not over-tighten the

anchors as this will render them ineffective, as well as damage the drywall. If you encounter a wall stud while

installing an EZ Anchor™ (E), use the mounting screw without the anchor. We only suggest using the

provided EZ Anchors™ since each one has a weight capacity of up to 50 pounds. Plastic anchors are not an

acceptable substitute.

Step 4.3 Install the Wall Bracket (H) using the 3 x 1” screws provided. Fig 2.C illustrates a correctly installed Wall

Bracket (H).

Section4‐MountingtheWaterFeature

Fig 3.4

Fig 4.1

1 2 3 4 5 6 7 8

Sem comentários

Bluworld of Water CSHDBM Manual de Instruções Página 5