Bluworld of Water CSHDBM Manual de Instruções descarregar pdf (Página 6)

Step 5.1 Unwind the Water Pump (A) and LED Light Fixture (C) power cords and run the wire for the light up and over

the back of the reservoir from behind the mirror As shown in Fig 5.1 . Make sure to run the LED Light Fixture

Step 5.2 Lift your waterfall into place and engage the bracket on the back of the fountain by lowering it onto the Wall

Bracket (H) as shown in

Step 5.3 After mounting your fountain to the wall, fill the reservoir with water. The water level must be maintained at

least ¼” above the Water Pump (A). If the water level drops below the Water Pump (A), damage may occur.

Step 5.4 You can now plug in your Water Pump (A) and LED Light Fixture (C) into your designated GFCI electrical

outlet.

Step 5.5 If necessary slowly open the Flow Valve (B) to achieve a nice water flow. As water begins to flow down the

panel, using the Water Guiding Pad (I) provided, you can guide the water to ensure that water flows down the

entire face of the panel evenly as shown in Fig 5.5. (Tip: Make sure when guiding the water with the Water

Guiding Pad (I) that your elbow is facing upward while guiding and spreading the water across the panel

during start-up. This will prevent water from running down your arm)

Step 5.6 Place Reservoir Tray in base as shown in Fig 5.6.

Section5:OperatingyourFountain

Fig 4.2 Fig 4.3

Fig 5.1 Fig 5.2

1 2 3 4 5 6 7 8

Sem comentários

Bluworld of Water CSHDBM Manual de Instruções Página 6